10 Nov
2005
10 Nov
'05
1:49 a.m.
Chuck Guzis wrote:
On 11/9/2005 at 8:09 PM Charles H. Dickman wrote:
A good suggestion that had not occurred to me. Unfortunately, I have a
difficult time even seeing the wire, let alone actually cutting it. I
can imagine unwrapping it and then tugging it out, but I don't have a
snippers small enought to cut it out.
-chuck
. Replace that run in the backplane.
I figure I will have to replace most of the run because this segment is
on the lowest wrap level and in the middle of the run, so I have to
replace this one and the ones on either side.
How about just clipping either side of the wire and adding a wrap on top,
leaving the bottom wraps in place? Is there room to do this?