15 Mar
1998
15 Mar
'98
5:57 p.m.
Well, I was finally able to make two QIC tapes (boot and install) using
NetBSD for x86. The tape drive ran fine, with no errors.
So then I hooked the shoebox up to the 3/50 that I have, and using the
monitor, issued "b st(0,6,0)" to boot from the tape. The 3/50 seems to
access the drive (I can see the heads move), but either aborts with a
"Device Not Found" error, or the following:
scsi getbyte failed
invalid status message = FFFFFFFF
st: sense key = 6 error = 29
I'm not able to get any further than this. Any thoughts??
Rich Cini/WUGNET
<nospam_rcini(a)msn.com> (remove nospam_ to use)
ClubWin! Charter Member (6)
MCP Windows 95/Windows Networking
============================================