10 Feb
2000
10 Feb
'00
11:43 a.m.
On Wed, 9 Feb 2000 20:00:47 -0800 (PST), Ethan Dicks <ethan_dicks(a)yahoo.com>
wrote
>With all the recent discussion, I'd like to
know what you are using for
>layout software.
On my web site, I have a paragraph or two about the EDWin NC package
that I'm using. In short, it has everything but the kitchen sink, but is not
terribly well integrated and requires too many mouse clicks to get simple
tasks done. To be fair, though, my speed seems to be improving with each day
that I use it.
Anyway, what I'm going to do is make DXF
pictures out of them and post
them to my site for all to see. Comments will be welcomed.
>Cool.
I may do it in PDFs instead or in addition to the DXFs. EDWin has a lame
printing system, so I'll have to see which one produces the best results.
Once the design is finalized, I'll have a
prototype board made so that
I
can see if it works.
>
>I'd also be interested in knowing who's burning your prototype and how
much
>it runs you. I still have delusions of completing
my 1802 SBC.
No problem. I'll probably pick someone out of Nuts & Volts or Circuit
Cellar.
Rich
[ Rich Cini
[ ClubWin!/CW1
[ MCP Windows 95/Windows Networking
[ Collector of "classic" computers
[ http://highgate.comm.sfu.ca/~rcini/classiccmp/
<================ reply separator =================>
?