20 Mar
2007
20 Mar
'07
12:10 a.m.
-----Original Message-----
From: cctalk-bounces at classiccmp.org
[mailto:cctalk-bounces at classiccmp.org] On Behalf Of Jay West
Sent: dinsdag 20 maart 2007 1:38
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: 11/45 works, but....
I checked tonight, and powering them both up (RL02 & RX02)
before the cpu makes no difference. If the RX02 is powered on
when the load button is hit on the RL02, the RL02 will fault
just after spinup. If the RX02 is powered off, the RL02
doesn't fault at any time and runs just fine.
My M8256 is set at address 177170, vector 264, priority BR5.
The M7762 is set at address 174400, vector 160, priority BR5.
I'm assuming both at BR5 isn't a problem?
Jay
Both at BR5, even if that was wrong would not cause your problem
with the RL02 the moment you turn on the RX02. If both at BR5 is
a problem it will occur when you do data transfers between the
RX02 and the RL02. I am not sure, but I *think* they are normally
both at BR5.
- Henk.
This message and attachment(s) are intended solely for use by the addressee and may
contain information that is privileged, confidential or otherwise exempt from disclosure
under applicable law.
If you are not the intended recipient or agent thereof responsible for delivering this
message to the intended recipient, you are hereby notified that any dissemination,
distribution or copying of this communication is strictly prohibited.
If you have received this communication in error, please notify the sender immediately by
telephone and with a 'reply' message.
Thank you for your co-operation.