24 Oct
2015
24 Oct
'15
10:54 p.m.
On Sat, 24 Oct 2015, Chuck Guzis wrote:
On 10/24/2015 09:49 PM, Eric Smith wrote:
I have a small pair of specialty pliers which were made to install roll
pins in relays which work equally well for this. Another tool I've used in
the past is a really small c-clamp.
I don't know if anyone else has tried them yet, but I recently discovered
that Richco/Essentra also makes card ejectors/extractors.
http://us.essentracomponents.com/shop/en-US/essentracomponentsus/pcb---elec…
What tool does one use to install the metal pin
into a plastic PCB
extractor, e.g., the Bivar CP-36 or Keystone 8642?
There are expensive tools for the purpose, but I've always just used a pair
of long-nose pliers to compress the end of the spring pin slightly to get it
started, then drive it home with a soft-faced mallet. Make sure that the
body of the extractor is supported.
To remove, an appropriately-sized roll pin punch works just fine without
mangling things.