4 Jan
2014
4 Jan
'14
12:24 p.m.
On 01/03/2014 04:22 PM, Brad Parker wrote:
On 12/15/13, 10:48 PM, Charles wrote:
Perhaps you already have the answer, I haven't read the whole thread.
But on my previous 11/23 it looks like this:
first at the RLV11: http://www.update.uu.se/~pontus/swec/rlv-flatkabel.jpg
Then the cab kit: http://www.update.uu.se/~pontus/swec/extern-flatkabel.jpg
And the external cable:
http://www.update.uu.se/~pontus/swec/extern-kontakt.jpg
/P
I'm looking for a BC80J-20 cable...
that's the one that goes from the
RL controller card to the first drive, with a 40 pin header on one
end and that big quick-release connector on the other end.
(I am tired of failures and damage to the rigged ribbon cable/IDC
header I've been using, and now that I'm chasing a fault in my
two-RL02 system, I can't swap drives without taking the cover off to
get to the header connectors inside).
I think I'm looking for one of these as well. Or maybe someone here
can point me to what I really want :-)
I have an RL02 driver and an RL02 controller, but I seem to have
lost/misplaced the "cabinet kit". I could swear I had one at one point.
So, the RL02 drive has a terminator and a nice long round cable which
seems to have a 2x.1" header. But I believe I need the cable part
which is normally install on the cpu cabinet. My guess is it would
cable a shielded ribbon cable with a connector for the board header
and the other end would have a metal bracket and something to mate
with the nice round cable...
Is this even close? 
