31 Dec
2018
31 Dec
'18
1:54 p.m.
On Dec 30, 2018, at 8:55 PM, Fritz Mueller via cctalk
<cctalk at classiccmp.org> wrote:
Hi all,
Some here may know I?ve been working on an 11/45 restoration off and on for some time
now. My ?45 currently has floating point, KT11-C mem mgmt, 124 kword MS11-L, and an RK11-C
with one restored RK05 drive.
Last week I decided to see if I could bring up RSTS/E on the machine. I managed to sysgen
a minimal V06C system that can run off a single RK05 pack under simh, but when I transfer
that image to the real hardware using pdp11gui it does not seem to completely/successfully
boot.
The ?Option:? boot loader comes up and sub-commands there seem to be working (in
particular, the ?HARDWARE? sub command shows correctly detected hardware and options).
When booting RSTS/E, after supplying date and time, the idle pattern starts on the front
panel (but just the bottom part, on the data lights). When console is in display register
mode, it shows an increasing count. Console input is echo?d, but the INIT banner and
subsequent prompts are never printed and the read light on the RK05 flickers continuously
as if the system is trying to read the same sector over and over.
Figured I?d ping here in case this is a known failure mode to folks more familiar with
RSTS/E? Also posted over on the vcfed DEC forum. FWIW, the machine is passing all MAINDEC
CPU, MMU, FP, KW11, and RK11 diagnostics.
Cheers,
?-FritzM.
The standard idle pattern is in the data lights. I don't remember if the
"fancy" pattern appeared in V7.0 or earlier, but in any case it's an
undocumented SYSGEN option.
In RSTS/E, the display register shows the system error count. That's from I/O errors
reported by the various drivers.
Do you have a second disk pack? If so, you could use the DSKINT option in INIT to
initialize a pack, with pattern tests. That would show what the RSTS disk driver thinks
of your RK05.
Something else you might try: when you start the system, don't enter line-feed for the
quick start, but the START command. That is a more verbose version which will display
some additional messages. If anything is getting disabled, it would show there.
paul