5 Feb
2019
5 Feb
'19
5:53 p.m.
On 05/02/2019 20:59, Chuck Guzis via cctalk wrote:
Some years ago, Jay recommended a Genie Load Lifter to me (thank you!),
and I was fortunate enough to get two of them as "new old stock" for
about half price. They're relatively inexpensive and absolutely
invaluable. Put a 200lb unit into the top of a full height rack? No
problem. Shame I had to leave both behind when I left that employment
(especially since they bought a third one but never used it)!
--
Pete
Pete Turnbull
On 2/5/19 12:19 PM, Jack Harper via cctalk wrote:
I learned that
very quickly - If you open the front of the Drive and
swing out the door with the electronics, drive motors etc, it is
definitely heavy enough to tip a rack.
I bolted the destination 19" rack down to the concrete floor with 3/8"
bolts.? It will not, I hope, soon go anywhere.
After struggling years earlier with getting a Fujitsu drive into a rack
by my lonesome, I was determined not to repeat the process. The rack,
VTW, is from an old HP Storage Array, which has a nice anti-tip pullout
on the bottom.
I constructed a dolly for the HP drive that allows me to roll it around
where I need it. It's low enough that it can slip under a table.