No worries Steve, thanks for looking. Actually, I think I'm covered at this
point.. I don't see anyplace to install it on the bottom of the 'B' board,
so I'll just assume that it was deleted as part of the B spec.
Stripped the chassis bare the other night, so I could clean it up well,
tighten / replace any bad fasteners, and _properly_ mount the 3" 95,000uF /
20V computer-grade cap. I want it to be right from the ground-up, and
there's no better time than the present to do that..
The previous owner must have lost the 3" cap clamp, as the cap was glued
in-place with what seems to be construction adhesive - like Liquid Nails,
and so on. Took some heat to get that one apart! But now it's all good, and
in the process of final assembly. I think I +might+ replace the main (8V)
bridge rect. with a more modern 35A / 100V part.. just because I can, and I
have them.
On Sat, Sep 20, 2014 at 5:51 PM, steve shumaker <shumaker at att.net> wrote:
On 9/17/2014 6:05 PM, steve shumaker wrote:
I'll look Sat and see what I have in the junk
box. May be able to help.
Steve
On 9/16/2014 10:00 PM, drlegendre . wrote:
Hey Steve,
On Tue, Sep 16, 2014 at 10:21 PM, steve shumaker<shumaker at att.net>
wrote:
I may have some at home (get back Fri night) but.... are you reasonably
close to Silicon Valley.....?
Steve
Closer than, say, the far side of the moon.. ;-)
(I'm in MN)
OK. Checked several places and do not have anything that will help...
(found one short piece of the 1/8" stuff but nothing larger) sorry!
and didn't make it to San Jose today so that so couldn't help there either
Steve
Steve