25 May
2016
25 May
'16
5:12 p.m.
On 2016-05-25 8:47 PM, jwsmobile wrote:
On 5/25/2016 4:29 PM, Fred Cisin wrote:
The 1403 was replaced by the 3203
which used the same print trains there
was also a faster 3211 that used a different train. Later there was the
4245 band printer which was a 3203 with a different front gate and later
the 6262 which was the last of the big impact printers. The 3211 was
announced in 1970 which may have been the end of the 1403, but people
where still using them long after that. The 3203 was announced around
1979 and had performance comparable to 1403 and used the same trains,
but did not have as good of a stacker.
The 6262 had electronic hammer timing which took away one of the really
tedious, not to mention deafening jobs in these printers. On the 3203
and 4245 each hammer had a set screw behind it that adjust the hammer
flight timing and you would run a H pattern and look for columns that
where off to one side adjust and run again and repeat until all 132
columns where looking good. On the 6262 there was a special setup tool
that was put in front of the hammers and connected to the printer, and
then you would run a test and it would electronically measure the timing
of each hammer and adjust the firing time accordingly.
I liked the big 3800 duplex setup, two 3800s where set up end to end
with precise spacing between them the paper was fed through one one 3800
and into the other with the paper being turned over between them. The
3800 printer also had burst and slit features available that the CEs
called rip and tear feature. Printing steadily a 3800 could empty a box
of paper in four minutes and it would detect the end of the paper and
stop before it fed all the way in and there was a fold down table with
pins on it so the operator could align and join on the new box so they
did not have to completely re-thread the paper.
Paul
On Wed, 25 May 2016, Noel Chiappa wrote:
The 1403 was
and is a great printer, but IBM didn't make a lot of
crappy ones. We had a 6262 and a 3xxx (don't recall it) with a
builtin channel both of which were great printers too. Don't forget
such as the laser engine coupled units either. Huge messes, but could
turn out amazing volumes of printed material. Those printers had an amazingly long life! They
were first
introduced in 1959
with the 1401 computer, and, like I said, the brand spanking new
System 3
they got in ca. 1976 came with one! I wonder when IBM stopped producing
them?
Did they discontinue the most long lasting printer that they had made