Resurrecting integrated circuits by cooking them.

Does this mean that, like me scratching a bit at the package to expose enough nub of broken-off pin to get a blob of solder on to hold a new leg made of wire can theoretically be extended to shaving off the top of the package to expose the IC and then tack soldering the severed wire back onto it? This would probably require some serious equipment I don't have, but sounds possible in extremity. RSVP YHOSvt. ** TNM ** Dwight said: "Message: 6 Date: Thu, 25 Jul 2019 05:52:31 +0000 From: dwight <dkelvey at hotmail.comTo: Pete Rittwage <peter at rittwage.com>, "General Discussion: On-Topic and Off-Topic Posts" <cctalk at classiccmp.orgSubject: Re: Resurrecting integrated circuits by cooking them. Message-ID: < BYAPR01MB5608F4C8A3860C2A7D2BC172A3C10 at BYAPR01MB5608.prod.exchangelabs.com Content-Type: text/plain; charset="us-ascii" "Failure of the POKEY chip were likely bonding wire failures. Voltage stress failures are not likely to self repair. I would agree, the fix is likely temporary. Many early chips used gold wire for bonding but later chips used aluminum. Which is better is always a question. The pads on the die were usually aluminum, while the package was often gold. These are acoustically bonded. One wonders if one put a capacitor on the lead with a non-lethal voltage and used such a heating method, it might be able to arc weld the wire back on. Using the method of heating might enhance the success as well. Dwight"