6 Jun
2003
6 Jun
'03
3:26 p.m.
On Fri, 6 Jun 2003, Antonio Carlini wrote:
It locks up during the diagnostics, most often during the memory tests.
I've managed to get it to go though to the point where it was ready to
boot a couple of times. It seems to get worse if I leave the system
powered up. I know its not the boards, since I've tried known good sets.
-Toth
I checked the
voltages on the drive harnesses, and +5VDC and +12VDC
seemed to be within the normal variance. I'll see if I can't check
+5VDC on some of the boards too. I guess if that checks out ok, I'm to
where I started, thinking that there may be noise on +5VDC and/or
+12VDC. Has anyone else had similar problems with the BA123 power
supply?
What does the console output look like when it locks up?