11 Jul
2015
11 Jul
'15
8:30 a.m.
The RL01/RL02 Users Guide (bitsavers.org/pdf/dec/disc/rl01_rl02) Figure
2-25 on page 2.35 describes the positioner restraining bracket that
should be put in place before shipping. It is just a little square
piece of metal (probably aluminum) with a single screw that holds it
down that sits in front of the carriage to keep it from rolling into the
pack area.
Of course, you don't want a pack in there while you are moving it
around. :)
It also mentions on that page a couple of shipping screws on the bottom
of the drive to restrain the spindle/blower motor from turning.
On 7/10/2015 11:11 PM, devin davison wrote:
I made a mistake. I was reading about the floppy drive
and accidentally
mentioned the rx01 / rx02. The hardware to be moved is actually RL01/RL02
hard drives, not the floppy drive. Please forgive the mix up, any help is
appreciated.