MEM11 update

Just wanted to let folks know where I am with respect to the MEM11 project. I had decided to take a break from writing J1 code and updating the simulator to actually work on the hardware. To make things easy for myself, I decided to use my FPGA eval board and build a daughter board with CPLDs and other parts (FRAMs, etc) so that I could have another vehicle for validating the J1 code. This should also be a fairly simple board to build and I could focus on functionality (and test points) rather than trying to make it fit into an SPC form factor. I wrote a lot of the Verilog code for the CPLDs and quickly found out that my partitioning wouldn?t fit in any reasonably sized CPLDs. Even with some additional re-partitioning, it was touchy as to if it would fit (changing a couple of lines of Verilog code caused the design to no longer fit). I went back and thought about the problem and decided that the easiest thing to do would be to create a non-SPC formfactor board that was SW & HW functionally correct. So, I?ve been working on writing all of the code to fit in an FPGA. One advantage is that I could re-use a lot of the code that I wrote for the CPLDs. Last night I managed to get a reasonably clean synthesis of the design. The only thing missing is the UNIBUS code (which I hadn?t written yet). It fits easily into the FPGA that I?ve chosen (a Xilinx Spartan 3-E 500). By going this route, I?ve discovered some incorrect assumptions that I?ve made in terms of how the HW will appear to the J1 code. So I have to update the simulator to match this and the relevant J1 code. So, things are moving forward. I also wanted to get folk's opinion on the need to actually produce an SBC form factor board. In other words (and sort of in line with how peripherals were done on the original 11/20) is it OK to have the MEM11 be outside of the 11/20 chassis and connect via BC11A (my replica) cables? I wanted to put that out, because it may require a fair amount of work to make everything fit into an SPC form factor. That?s assuming of course that the power requirements for the MEM11 can be fulfilled by a single SPC slot. One of the things that I can do with the ?prototype? is actually measure the incoming power. I?m hoping that it will but in the worst case, it may require splitting the MEM11 functionality across multiple boards. TTFN - Guy