2 Jun
2007
2 Jun
'07
9:41 p.m.
Chuck,
Thanks for the good ideas. I don;t recall amny S-100 with the regulators
at opposite corners, but then they did make a lot of designs back then.
The ones I own have them situated on the same edge.
I'll look in incorporating some of this into the design. The power
traces are double sided, I only made a pic of the bottom side before.
=Dan
[ My Corner of Cyberspace http://ragooman.home.comcast.net/ ]
Chuck Guzis wrote:
On 2 Jun 2007 at 10:26, Dan wrote:
I've been working on a pcb design for a S-100
prototype board...
For whatever my tuppence will get you today, I'd like to submit that
I'd prefer to see one regulator (+12, +5) at each corner, rather than
both at the same corner--better heat dissipation.
I'd also like to see a row of pads at the top for a 50-position
ribbon cable connector or two.
The orientation of the packages is fine. I'm assuming that the power
traces are duplicated on the reverse side of the board also.
I hope some of this makes some sense to others.
Thanks,
Chuck