12 Jul
2015
12 Jul
'15
12:24 a.m.
Note that the bracket should already be there; just loosen the screw,
rotate the plate 90 degrees to block the positioner-mount, and then tighten
the screw again. I *think* that the bottom drive-retention screws are
interchangeable with screws on the back-panel, and a typical approach is to
remove a pairs of screws from the back panel for temporary reuse to
stabilize the motor, then return to their former locations after re-racking.
On Sat, Jul 11, 2015 at 11:30 AM, Jay Jaeger <cube1 at charter.net> wrote:
The RL01/RL02 Users Guide
(bitsavers.org/pdf/dec/disc/rl01_rl02) Figure
2-25 on page 2.35 describes the positioner restraining bracket that
should be put in place before shipping. It is just a little square
piece of metal (probably aluminum) with a single screw that holds it
down that sits in front of the carriage to keep it from rolling into the
pack area.
Of course, you don't want a pack in there while you are moving it
around. :)
It also mentions on that page a couple of shipping screws on the bottom
of the drive to restrain the spindle/blower motor from turning.
On 7/10/2015 11:11 PM, devin davison wrote:
I made a mistake. I was reading about the floppy
drive and accidentally
mentioned the rx01 / rx02. The hardware to be moved is actually RL01/RL02
hard drives, not the floppy drive. Please forgive the mix up, any help is
appreciated.