26 Jun
2002
26 Jun
'02
4:59 p.m.
On Wed, 26 Jun 2002, Fred Cisin (XenoSoft) wrote:
On 26 Jun 2002, Jeffrey H. Ingber wrote:
And make sure that J4 & J5 are jumpered to AT/Compaq if your connection
is from FDC to the card-edge on the DOB.
- don
That makes quite a bit of sense, and how I
remember the cabling as
well. I need to make a suitable cable to go from the drive controller
to the option board it would seem. The issue is probably whether or not
the cable has a twist - I would assume it would NOT, since the standard
floppy cable would take care of that.
No twist.
Just straight 34 pin ribbon cable with a dual row header on one end and a
card edge connector on the other. You could take an old AT floppy cable,
and cut it off before the twist. That's a bit longer than you need, but
works fine. Looking at the
stylized picture on the manual cover, it appears the OB
is replacing the drive controller. Needless to say this doesn't mean
DOES
NOT
Would anyone happen to have a manual that could
confirm our suspicians?
Don't need no stinkin' manual.