30 Jul
2006
30 Jul
'06
1:09 p.m.
what if you drill your holes first? Would that at all
alleviate the problems experienced with a double sided
etch? I figure I could lay out a copy of the artwork,
dimple each hole with an awl or whatever, then drill ,
which will hopefully facilitate accurate placement of
the transfer sheets. Farming out is likely to be
expensive I guess on a very small quantity. The board
is about 7.5 inches square (Radio Electronics 80188
robot brain).
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com