17 Oct
2010
17 Oct
'10
8:32 a.m.
Yes I thought about that and I tried changing it to "on" but it did not make
a difference; and with the "diff" setting it does seem to work, at least
some of the time.
I also just found out something strange. If I remove any devices with a SCSI
ID numerically lower than the CD-ROM then both the CD-ROM and the higher
HDDs are still seen after the SCSI reset. To prove this I took out DKA600
and changed the SCSI ID of DKA0 to make it DKA500. This time, after the
reset, it recognised both the CD-ROM (ID 4) and the disk that was at ID 0
and now was at ID 5.
Regards
Rob
-----Original Message-----
From: cctalk-bounces at classiccmp.org [mailto:cctalk-
bounces at classiccmp.org] On Behalf Of Adrian Graham
Sent: 17 October 2010 15:17
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: More SCSI Confusion
On 17 October 2010 11:44, Rob Jarratt <robert.jarratt at ntlworld.com> wrote:
The QLA1040 isn't differential is it? The soft_term should be just 'on' I
think.
>>sh
pk*
pka0_host_id ? ? ? ? ? ?7
pka0_mode ? ? ? ? ? ? ? ultra
pka0_soft_term ? ? ? ? ?diff
--
adrian/witchy
Owner of Binary Dinosaurs, the UK's biggest home computer collection?
www.binarydinosaurs.co.uk