Unusual rt-11 msg

do u have a tk50 tape drive? On Fri, Jul 13, 2012 at 12:55 PM, Wadoco <quapla at xs4all.nl> wrote: > > An imaged rl02 containing rt-11 5.7 distribution disk > generated a bit of an odd message after booting in in simh (v3.81). > > It came with the following output : > > sim> att rl0 rt11_V5.7.dsk > sim> boot rl0 > > RT-11FB V05.07 > > RT-11 V5.7 > > Installation of RT-11 Version 5.7 is complete and you are now > running > RT-11 from your system volume. > > Your system volume is your working volume if you have used the > Automatic > Installation (AI) procedure. If you have installed RT-11 using > that > procedure, Mentec recommends you verify the correct operation of > your > system's software using the VERIFY verification procedure. You can > only > perform VERIFY on the valid target (output) media you used for the > AI > procedure. Run VERIFY before you run CONFIG. To run VERIFY, enter > the > command: > IND VERIFY > > You should read the file V5NOTE.TXT, which you can TYPE or PRINT. > Also, > read the Introduction to RT-11, and the Installation Guide which > contain much of the information you need to use RT-11 Version 5.7. > > > .R MSCPCK > ?MSCPCK-I-MU0-TK50 FW Rev Level is 005/HW Rev Level is 001 > ?MSCPCK-W-TUK50 controller below FW Rev 4/HW Rev 2 > > . > > ======= > > Anybody have a suggestion about the last 2 error messages? > and can it be easily fixed in the simh code? > > Ed > >