8 Sep
1997
8 Sep
'97
4:44 a.m.
The floppy drive incidently, works on other c64's just fine, and I have
cleaned and calibrated it.
----------
(4),
From: jpero(a)mail.cgo.wave.ca
To: Discussion re-collecting of classic computers
<classiccmp(a)u.washington.edu>
Subject: Re: Sick C-64c
Date: Monday, September 08, 1997 4:38 AM
> Date: Mon, 8 Sep 1997 08:22:06 -0500
> Reply-to: classiccmp(a)u.washington.edu
> From: "Bill Girnius" <thedm(a)sunflower.com>
> To: "Discussion re-collecting of classic computers"
<classiccmp(a)u.washington.edu>
Subject:
Sick C-64c
X-To: "Classic" <classiccmp(a)u.washington.edu>
> I recently aquired a stack of c64's, these are the old brown type. Of
> One works fine, 1 boots, and can run catridges,
initializes the floppy
on
> boot, but can never access it after boot, the
other two have power but
no
video. Any
ideas on these folks?
Checkerboard or no display usually means memory is bad, replace all
64k ram chips.
Oddball problems usually traced to the VIA ic's blown by unbuffered
lines. Real easy to do to blow it if careless!
Make sure you put the shield back on with those finger "pads" coated
with bit of heatsink paste on them, they're like poorman's heatsinks!
The video IC get brutally hot!
Monitor the voltages for stablity and good idea to replace those big
capacitors just in case. The floppy drives I think is belt driven
type and needs bit of cleaning. I had a problem with one, inside
that small can there's 2mhz crystal and one TTL chip, That TTL chip
was baddie.
Jason D.