Unibus Termination KnowledgeQuest

Van: cctalk-bounces at classiccmp.org namens John A. Dundas III Verzonden: vr 13-10-2006 16:54 Aan: General Discussion: On-Topic and Off-Topic Posts Onderwerp: RE: Unibus Termination KnowledgeQuest Trimmed the messages a bit... At 1:33 PM +0200 10/13/06, Gooijen, Henk wrote: /Henk, /I noticed this in your pictures. Interesting. I have the print set /here too and I'll look also. While I personally haven't powered the /machine up yet, I'm fairly certain it was running just prior to my /acquisition from a former DEC FE. [I don't mean to implicate him if /indeed the module should be in 1EF as it's possible the machine /wasn't working and/or I might have inadvertently moved a few things /around.] / /John Hi John, just to be sure I did not make any errors on my website, I checked the 11/70 field maintenance print set, MP00824. On page 6 is clearly slot 1 E-F for the terminator, with notes to it which are on page 2. It only says that you install M930? or M9312, but not both ... So, your system with the M9312 in slot 1 A-B is a bit of a puzzle. I have not found what the usage is for slot 1 A thru D. Perhaps diagnostic hardware? But my scans are the earlier ones, done as TIFF, not PDF. In Win98SE easy to browse, but in WinXP a PITA. - Henk. This message and attachment(s) are intended solely for the use of the addressee and may contain information that is privileged, confidential or otherwise exempt from disclosure under applicable law. If you are not the intended recipient or agent thereof responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately by telephone and with a "reply" message. Thank you for your cooperation.