13 Jun
2012
13 Jun
'12
4:32 a.m.
The 3900/uvax III is running VMS. The terminal doesnt have an OS, its just in DTE mode.
I haven't figured out how to change the terminals settings. This is why I was looking
for the manual.
Kevin
Date: Wed, 13 Jun 2012 02:49:01 -0400
From: mcguire at neurotica.com
To:
Subject: Re: DEC VT1300 (VXT1300) manual around
On 06/12/2012 07:12 PM, Kevin Reynolds wrote:
I have looked through bitsavers and some other
old vax manual
repositories online and I haven't found a manual for the DEC VT1300.
I did an installation and service manual for the VR320 monitors I
have, but they only cover the display. I have worked out alot of
details about the vt1300 system, and have gotten one working 100%,
but haven't figured out what terminal emulation the terminal
personality of the unit uses. It works 95% with the vax 3900 I have
it attached to, but from time to time I see what I assume as vt100
control codes in the output stream. I assumed that that unit used
vt100 emulation out of the box, and that the vax console would go
this way as well, but perhaps I'm wrong. It could be that the vax is
vt52 some other terminal type by default, or that the 1300 does
vt102, or vt220...
I assume you're running VMS?
What exactly are you seeing? It's possible (even likely) that you're
seeing overruns. Try dropping the baud rate, just experimentally, to
see if the problem goes away.
-Dave
--
Dave McGuire, AK4HZ
New Kensington, PA