The only
problem is that the boot ROMs, which are on the WH-27 card,
don't know how to boot a RL02. Any ideas?
I seem to remember that if you configure RT11 with the RL11 handler
(DL.SYS IIRC) and boot that (e.g. from RX01 floppies) you can then do a
BOOT /FOREIGN DL0: to boot the RLs.
You can also do the following:
Make sure you have a bootable RT volume with the DX.SYS and DL.SYS
device drivers. Make a copy of it. For the copy (and I'm assuming
it is mounted in drive 1 with the system in drive 0), issue the
following command:
COPY/BOOT:DL DX1:RT11SJ.SYS DX1:
(or substitute the monitor filename for RT11SJ above).
What this will do is create a diskette which, when booted, will
actually boot the corresponding unit of the DL drives.
If you place this in drive 0 and boot it, the system will be
loaded and will run from DL0.
Megan Gentry
Former RT-11 Developer
+--------------------------------+-------------------------------------+
| Megan Gentry, EMT/B, PP-ASEL,ST| email: mbg at
world.std.com |
| Member of Technical Staff | megan at
savaje.com |
| SavaJe Technologies, Inc. | (s/ at /@/) |
| 100 Apollo Drive | URL:
http://world.std.com/~mbg/ |
| Chelmsford, MA 01824 | "pdp-11 programmer - some assembler |
| (978) 256 6521 (DEC '77-'98) | required." - mbg KB1FCA |
+--------------------------------+-------------------------------------+
