[SPAM] - Re: Suggestions for VT103? - Sending mail server found on dnsbl.sorbs.net

Jerome Fine replies: Don't forget that both ABs in each slot need to be wired in since each quad slot can hold 2 dual boards. That means a total of 8 solder joints for each address line and a total of 32 solder joints for all 4 address lines. Very fine insulated wire wrap seems to be a good solution. The plastic insulation can be stretched after each solder joint is made to cover the wire right up to the solder joint. A wire stripper can be used to custom cut the insulation at the exact spot needed - cut a bit short and stretch the insulation after the solder is cold. Then daisy chain from slot to slot as needed. Start with the first solder joint with about 2" of free wire, then custom cut the insulation to the correct length for the second solder joint on the same slot (second AB on that slot). It probably helps to keep the wires as neat as possible since the next address line is very close. Ethan answered this much better than my limited knowledge! Sincerely yours, Jerome Fine