how do I copy an RD54 completely?

I have an RD54 with a working RSTS system (V10.?) on it. The RD54 was installed in the microPDP-11/93 that I had. I have a microPDP-11/53 with RQDX3 and got a few days ago an Emulex UC07 QBUS SCSI interface with a 1 Gb SCSI disk. Before I mess up the RSTS (because I don't know anything about RSTS yet), I would like to make a copy (dump?) of the complete RD54 to the SCSI disk, so I can restore the whole RD54 to an other RD54 if this one dies ... or is messed up completely by me :-) I think the following steps are a starter (?): 1) install the UC07 and connect the SCSI disk 2) connect the RD54 to the RQDX3 3) start the system till the RSTS "Option" prompt Then what? First, I need to know the device names. Is there some command like RT-11 ".SH DEV" available in RSTS? Then I probably need to initialise the SCSI disk? Then I need some sort of command to get *everything* Any help is appreciated! TIA, - Henk, PA8PDP This message and attachment(s) are intended solely for the use of the addressee and may contain information that is privileged, confidential or otherwise exempt from disclosure under applicable law. If you are not the intended recipient or agent thereof responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately by telephone and with a "reply" message. Thank you for your cooperation.