5 Jun
2006
5 Jun
'06
8:46 p.m.
dave06a at dunfield.com wrote:
IMHO, and essential tool if you are serious about
doing any kind of
rework is a good desoldering station. Takes a bit of time, but if done
it right, the chip just lifts out with no damage to it or the board. One
of the best investments to my workbench that I ever made....
projects. The SBC6120 is good reason to get a better iron for me now.
I take it was tossup between a scope and good soldering iron
for the first best investment once you get off the kitchen table for
projects. The SBC6120 is good reason to get a better iron for me now.
PS. I notice most TTL projects are wire wrapped that I have seen on the
web rather than having a PCB made.