25 May
2005
25 May
'05
2:18 p.m.
Tom Jennings wrote:
For neon, from flawed memory, strike-over is around
100V, and
sustain around 80V. [...] You could probably make a coincident-voltage
memory from them... but they'd be slow I think, but pretty.
Sounds like a fun project!
Lessee... If the numbers are 80V and 100V...
You have an X-Y matrix. Steady state, you apply +7.5V to each X line,
and +97.5V to each Y line, so each tube has 90V across it.
You turn on a particular tube by dropping the X line to 0V and raising
the Y line to +105V. The selected tube sees 105V, while the other tubes
in the same row and column see 97.5V.
I'm guessing that if you measure the current in those lines, you can
tell when it strikes, or maybe you just wait long enough before dropping
the lines back to the steady state.
To turn off a particular tube, you raise the X line to 15V and drop
the Y line to 90V. Now there's only 75V across the selected tube,
while other tubes in the same row and column will still have 75V.
Again, there should be a current drop when the selected tube turns
off.
And you read a tube either by trying to turn it on, or trying to turn
it off. If the current doesn't change enough, it hasn't flipped.
The voltages will need to be controlled fairly well, since the
margins are narrow.
Will neon bulbs have reduced lifetime if you run them on DC?
Eric