16 Aug
2019
16 Aug
'19
6:59 a.m.
Paul,
I've got a board house I usually use, but if I can find a shop in the USA
that will do hard gold plating and provide a comparable cost-per-board, I'd
certainly switch!
Thanks,
Jonathan
On Fri, Aug 16, 2019 at 12:55 AM Paul Anderson <useddec at gmail.com> wrote:
Hi Jonathan,
If you are looking for someone to make the boards, I know someone in CA.
I'll try to dig up his contact info this weekend.
Paul
On Wed, Aug 14, 2019 at 7:14 PM systems_glitch via cctalk <
cctalk at classiccmp.org> wrote:
Connor Krukosky and I have been working on laying
out a new quad-height
DEC
protoboard, which can also be sheared down into a dual-height board. Full
announce on the VC Forums:
http://www.vcfed.org/forum/showthread.php?71177-GW-DEC-1-A-New-Quad-Height-…
These should be available within a month or so. I'll be putting up a
preorder soon to gauge interest in the production run, which as usual will
have hard gold plating on the edge connectors. I haven't gotten a quote
for
the cost, but I expect them to be $30-40 each for production boards.
They'll be available at VCF Midwest as well as online!
Thanks,
Jonathan