15 Jan
2015
15 Jan
'15
11:46 p.m.
On 2015-01-16 05:39, Kyle Owen wrote:
On Thu, Jan 15, 2015 at 9:47 PM, Johnny Billquist
<bqt at softjar.se> wrote:
By the way - as far as newcomers go. I hope you are aware that the full
manual set is available on bitsavers. It's a lot to read, but start with
a few simple manuals like "Introduction to RSX", which is really basic.
And then some manuals about utilities and system management.
Of course, you can also just ask, and I'll try and answer. :-)
Johnny
--
Johnny Billquist || "I'm on a bus
|| on a psychedelic trip
email: bqt at softjar.se || Reading murder books
pdp is alive! || tryin' to stay hip" - B. Idol
There have been lots of positive comments, and
obviously some people have
even tested using the software.
I shall echo the sentiments of others; thanks for releasing this!
So - same as before. Disk image and tape image are available at
Madame.Update.UU.SE. Use anonymous ftp.
Disk image is also available at ftp://ftp.update.uu.se/pub/pdp11/rsx/tcpip
.
The disk image is a virtual RL02 disk. Can be used with any emulator, or
also directly inside RSX if you have virtual devices available.
Johnny, you mentioned you're running under E11. Has anyone tried it under
SimH yet? I put together an 11/70 1MB system under the PDP-11 emulator
(built with Ethernet support under OS X 10.9) and have installed
RSX-11M-PLUS 4.6. When I was installing, SYSGEN reported 512k of RAM
instead of 1M, which alarmed me. I went into manual mode and told it
explicitly 1M. That's been my only hiccup so far, and that's about where
I'm at. If anyone has any suggestions for a newcomer to RSX, I'd certainly
appreciate it. I'd be more than willing to write up a tutorial if someone
can help me the rest of the way.