28 May
2010
28 May
'10
9:54 p.m.
On Sat, 29 May 2010, Keith M wrote:
Gene Buckle wrote:
Thanks Keith.
I've tested the Vcc pins on all the chips that are on the board and none
show +5. The A500 works without issue so I know the power supply is ok.
I can find +5 on the .100 dual pin header that the memory expander plugs
in to, but no where else. +12V does show up on the molex power connector
for the drive.
I've also checked both sides of what look like tantalum caps and I get no
power there either. I can't see any visible damage to the board, no cut
or scratched traces, etc. I'm at a total loss as to why it's not getting
any power.
g.
--
Proud owner of F-15C 80-0007
http://www.f15sim.com - The only one of its kind.
http://www.simpits.org/geneb - The Me-109F/X Project
ScarletDME - The red hot Data Management Environment
A Multi-Value database for the masses, not the classes.
http://www.scarletdme.org - Get it _today_!
I've got a DataFlyer 500 expansion for my
Amiga 500 and it's dead as a
post. There's +5 on the connector but no where else that I can find on the
board. Does anyone here happen to have a schematic for it or know where I
can find one?
tnx.
g.
Gene,
I've got one of those. I haven't seen a schematic. Mine works fine. If you
want to provide detailed instructions on exactly what measurements, etc you
need, I can do them. I also have the installation disk too, if you need.
I'm tied up for the next couple days, but I'll be free after that.