14 Jun
2015
14 Jun
'15
8 a.m.
On Jun 14, 2015, at 06:53, Michael Thompson
<michael.99.thompson at gmail.com> wrote:
Dave Tumey sent us a new rubber hammer for the Teletype. This is the part
that pushes the print drum against the ribbon and paper to print. These are
newly molded parts that have not been available for decades. Works very
nicely.
I should order one, too. I'm presently using the rubber tubing over the hammer
kludge.
The donor dropped off the work table that goes in
front of the PDP-12. We
need to loosen the rusted feet so it will fit under the front panel.
That sounds like a good excuse for more pictures!
--
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/