23 May
2016
23 May
'16
9:53 a.m.
On Mon, 23 May 2016, Ethan Dicks wrote:
Thanks for the pointer, but the closest match (not
exact), was still $10
for one belt.
I've seen folks make belts from heat-shrink tubing. Also, o-ring splicers
can be used to create small belts, but it's an expensive solution just to
get one belt. I'm not sure either one would create a belt precise enough
to work with your drive, though. Where I've seen the latter techniques
used is mostly on pully systems for homemade robots and other DIY
machines.
-Swift