7 Apr
2016
7 Apr
'16
1:58 p.m.
Err.. unless the voltage of the switcher is identical to that of the 7805,
then one device will source current, and the other will sink it.
Like putting two 6V batteries in parallel, where one is fresh and the other
weak. Current will flow until the potentials are equalized. But with two
regulated circuits, I don't see how equality can be achieved.
Not saying it's going to smoke-out, but it does seem like a wonky thing to
do.
On Thu, Apr 7, 2016 at 3:41 PM, wulfman <wulfman at wulfman.com> wrote:
You should be just fine.
On 4/7/2016 1:38 PM, Bill Sudbrink wrote:
If you have a circuit which is normally designed
to
operate with an unregulated supply, through a regulator...
say unregulated +8 through a 7805 to a regulated +5 and
you want to test it independent of the +8 supply, if
you leave the unregulated rail unattached and put +5
switcher straight onto the regulated +5 rail, will you
damage the 7805? Clearly the VIN is open, but the ground
pin will still be attached. Would this push voltage
back through and screw things up?
Thanks,
Bill S.
--
The contents of this e-mail and any attachments are intended solely for
the use of the named
addressee(s) and may contain confidential and/or privileged information.
Any unauthorized use,
copying, disclosure, or distribution of the contents of this e-mail is
strictly prohibited by
the sender and may be unlawful. If you are not the intended recipient,
please notify the sender
immediately and delete this e-mail.