10 May
2013
10 May
'13
1:07 p.m.
Yes it sure SEEMS like it's a straight through. I went ahead and ordered
one so I'll cross my fingers.
Thanks
-Beau
On Wed, Dec 31, 1969 at 8:39 PM, Tony Duell <ard at p850ug1.demon.co.uk> wrote:
--
Sent from My Hippopotamus
Does anyone know if the 5161 uses a special pinout or if it's simply a
straight-through cable (i.e. pin 1 to pin 1)? I've been searching but
haven't found any answers.
Accordign to the O&A TechRef 'The extender card and receiver card
rear-panel connectors are the same. Pin and signal seeignements for the
extender and receiver cards are shown below"
The 'externder card' is the oen that goes i nthe 5150 or 5160. The
'receiver card' is the one that goes in the 5161. I read that as saying
that the cable is straight-trhough. BUT, it would not suprise me if some
signals weere wired as twisted paris with ground. Unfortunately i don;'t
have the cable to hand so I can't take the hoods off and look at the wires.
Anyway, here is the pinous of the DC62 connector :
1 : EIRQ6
2 : EDRQ2
3 : EDIR
4 : EENABLE
5 : ECLK
6 : EMAEMINEXP/
7 : EA17
8 : EA16
9 : EA5
10 : EDACK0/
11 : EA15
12 : EA11
13 : EA10
14 : EA9
15 : EA1
16 : EA3
17 : EDACK1/
18 : EA4
19 : EDACK2/
20 : EIOW/
21 : EA13
-------
22 : ED5
23 : EDRQ1
24 : EDRQ3
25 : RESERVED
26 : EALE
27 : ET/C
28 : ERESET
29 : EAEN
30 : EA19
31 : EA14
32 : EA12
33 : EA18
34 : EMEMR/
35 : EMEMW/
36 : EA0
37 : EDACK3/
38 : EA6
39 : EIOR/
40 : EA8
41 : EA2
42 : EA7
--------------
43 : EIRQ7
44 : ED6
45 : EI/OCHRDY
46 : EIRQ3
47 : ED7
48 : ED1
49 : EI/OCHCK/
50 : EIRQ2
51 : ED0
52 : ED2
53 : ED4
54 : EIRQ5
55 : EIRQ4
56 : ED3
57 : GND
58 : GND
59 : GND
60 : GND
61 : GND
62 : GND
(E = Extended, a buffered verison of the I/O slot signal of that name)
-tony