12 Oct
2020
12 Oct
'20
8:04 a.m.
In a 'real' RX01, each sensor LED (track 0 and
index) has the cathode
grounded and the anode connected to +5V via a 68ohm series resistor.
If you measure the voltage across the pins with the LED disconnected
(or if the LED is open-circuit) with any reasonable meter, it'll read
5V. The meter will not draw enough current for the resistor to drop a
noticeable voltage.
Ok, that makes sense. Is the resistor on the board or on the drive wire
harness somewhere?
I'll jumper the disk 0 sensor into my test board here (actually just the
extender board from another PDT11) and see what the voltage looks like,
then compare it to the same spot on the second drive.
The thing that puzzles me is why you read 5V across an
LED that seems
to work on the bench. I wonder if a connection is open somewhere.
Not many places for the connection to be open: The LED most certainly
did work and did provide IR light on the bench and in-circuit. Weird.
C