RX02 emulator

Hi Doc, I catched this topic in my spam filter, don't know how it got there ... I have built the prototype for Pete and tested it in my 11/34A. In 3 words: it works great! You install the board in an empty UNIBUS slot, position C-D. Further, you need a M105 in position E, and a M7821 in position F, IIRC, but Pete's website explains it all. See http://www.pdp-11.nl/rx11emul.jpg for the RX11 emulator in action, or search the Classiccmp archive, two weeks ago or so ... BTW, if your system has the (real) RX11 (for RX01) or RX211 (for RX02) installed, you must either remove that module, or configure it at on other CSR. Also, Pete's RX11 board does *not* short-circuit NPR (CA1-CB1), so check the backplane, or (what I did) solder a short on Pete's board. Remember the NPG of the RX211! I asked Pete if he is willing to develop a PCB for the RXV11 (qbus) too, and he said that as he has the board"fingers", that would be do-able. So, if enough people ask for the RXV11 ... I'd like one! - Henk, PA8PDP. This message and attachment(s) are intended solely for the use of the addressee and may contain information that is privileged, confidential or otherwise exempt from disclosure under applicable law. If you are not the intended recipient or agent thereof responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately by telephone and with a "reply" message. Thank you for your cooperation.