13 Jan
2006
13 Jan
'06
1:55 a.m.
Great! Thanks Vince.
IIRC, I have also gotten the IOTs for the RF08 from Dough's
site, (and the 'tricky' ones like GTF and RTF), but somehow
I did not see this RX01 page!
I have printed those pages already to study them!
- Henk, PA8PDP.
-----Original Message-----
From: cctalk-bounces at classiccmp.org
[mailto:cctalk-bounces at classiccmp.org] On Behalf Of vrs
Sent: vrijdag 13 januari 2006 10:40
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: looking for RX01 device IOTs for the PDP8/e
From: "Gooijen, Henk" <henk.gooijen at oce.com>
This message and attachment(s) are intended solely for the use of the addressee and may
contain information that is privileged, confidential or otherwise exempt from disclosure
under applicable law.
If you are not the intended recipient or agent thereof responsible for delivering this
message to the intended recipient, you are hereby notified that any dissemination,
distribution, or copying of this communication is strictly prohibited.
If you have received this communication in error, please notify the sender immediately by
telephone and with a "reply" message.
Thank you for your cooperation.
Can anybody point me to where I can get the pdp8
RX01 IOT
descriptions?
Here's a place that I have used
http://www.cs.uiowa.edu/~jones/pdp8/man/rx01.html
It is easier (and harder) than you expect because the
interface is to the bit-slice micro-controller in the drive,
rather than to the bare drive electronics.
Vince