2 Dec
2003
2 Dec
'03
8:45 p.m.
On Wed, 3 Dec 2003, Pierre Gebhardt wrote:
Megan, do you know the jumper settings for the KFQSA ?
Although I'm not as sweet as Megan,
Or anyone else ?
oh.. this would apply though
:)
Yesterday I did another try.
The KDA50 works now at address 172150, with the KFQSA removed. The command "show
qbus"
finally lists the controller.
Yay!
Antonio named I link for KFQSA documents but they
don't have documents online for it.
How do I have to set jumpers for this board?
You dont have to, all programming is
done in software. But, since
you asked:
http://www.pdp11.nl/Documentation/NewMDS/VOL002/0346.pdf
My VAX4000 found the RA-92, attached to the KDA
(DUA0).
OK.
The userguide of the KDA50 refers to a programm called
MDM in order to do some diagnostics with the KDA and FORMAT the harddrive.
My idea is to boot NetBSD over Ethernet and install it on the RA-92 (there are no other
drives installed in the VAX!).
Can BSD find the drive directly, format it and be installed on it, or do I have to need a
special programm as MDM to format the drive?
It can just install it.
Cheers,
Fred
--
Fred N. van Kempen, DEC (Digital Equipment Corporation) Collector/Archivist
Visit the VAXlab Project at http://www.pdp11.nl/VAXlab/
Visit the Archives at http://www.pdp11.nl/
Email: waltje(a)pdp11.nl BUSSUM, THE NETHERLANDS / Sunnyvale, CA, USA