Testing H745 Regulators

I am trying to test a couple of H745 regulators with a DC bench PSU and I am having some problems with testing them. My bench PSU is a twin unit so I can supply the +15V required as well as the "AC" input using 20VDC from the other half of the bench PSU. The problem is that I don't think the bench PSU can supply enough startup current to allow the regulator to run. It can only supply 5A max. I have seen with the H744s that if I put too big a load on them, then they can't start because of the heavy startup current required. I can start them with a lower load and then add load once the regulator is running without breaching the current limit of the PSU. With the H745s I have tried reducing the load to see if I can get them to start, but a 10R load appears to be too much and the regulators draw the full 5A without outputting -15V. I have two H745s, both exhibit the same behaviour. I suppose they could both have the same fault, but I am inclined to think that perhaps they need a higher startup current than I can supply. Can anyone confirm this? Thanks Rob