12 Apr
2019
12 Apr
'19
9:07 p.m.
Hi Eugene,
I found my Emulex boards, but found TU13s and not QT13s. I did not look at
the S box boards.
Then I found a few Cipher Data Products ( AKA Spectra Logic Products)
500A00s. I'm not sure what they are, but they look like re-branded Emulex
with different handles.
Did Dilog or anyone else make anything else that would work?
Paul
On Fri, Apr 12, 2019 at 9:37 AM W2HX via cctalk <cctalk at classiccmp.org>
wrote:
Great, thank you to everyone!
This is what I purchased...
https://www.ebay.com/itm/171171330190
looks to be the right thing. I would have made it myself but I'd have to
buy like 50 feet minimum of the ribbon plus connectors plus shipping plus
my time. This seemed like a good compromise.
________________________________________
From: cctalk <cctalk-bounces at classiccmp.org> on behalf of Glen Slick via
cctalk <cctalk at classiccmp.org>
Sent: Thursday, April 11, 2019 9:10 PM
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: Fujitsi 2444AC 9-track tape drive/PDP-11
On Thu, Apr 11, 2019 at 5:55 PM W2HX via cctalk <cctalk at classiccmp.org>
wrote:
Question to owners of the 2444AC. I have been looking to acquire the
Emulex QT13
but cannot find anything on ebay (I did miss one early on and
wanted to kick myself). Anyone have one available for purchase?
Second question. The cable that I need to make here. Can anyone confirm
I need to
female IDC connectors on each side? (the tape drive and the QT13
have male pins)?
Thanks
That reminds me I need to check to see how many QT13 boards I
currently have and see if I have one to spare.
This picture shows the SUN configuration female D-shell connectors
with ribbon cables running to the two 50-pin Pertec interface
connectors on the cache controller board:
http://w2hx.com/x/VintageComp/Fujitsu-2444AC/0306192310.jpg
If you remove those 'A' and 'B' ribbon cables then you just need a
pair of 50-pin cables with female IDC connectors on one side, and if
you are using a QT13 then female IDC connectors on the other side as
well.
You need to check the connector pinout tables in the 2444AC manual
against the QT13 manual to see which connector on the 2444AC goes to
which connector on the QT13 so you don't get the cables crossed. I
forget without checking the manuals myself.
