16 Dec
2019
16 Dec
'19
7:57 p.m.
Well, I did check the head pretty thoroughly before installing it: One
problem was there were dirt particles that were not coming off so I used
the tip of a tweezer to loosen them up. Note I do this to watch dial
faces from the 1870's (oddly enough also porcelain) so I'm pretty
careful and am not making major scratches into that ceramic head.
But I did a finger check, it's smooth.
I'm wondering if the problem is the leading edge of the head is angled
down or something: From the debris on the leading edge it's looking like
it is digging into the pack. Not sure if this can be adjusted, or even
what adjusting the head would be like.
Interesting. I'll check the pack next weekend for damage before trying
it in the good RL02 to see if it has any more errors on the disk.
C
On 12/16/2019 7:23 PM, dwight via cctalk wrote:
The head likely has something on it that you missed.
Use your finger to feel the head. Your finger is quite sensitive to tiny roughness. Of
course, clean your finger oil off before putting it back in. Make sure that first landing
area is smooth and flat. Almost all of the head needs to have the cushion of air. With
things stationary, look at how the head comes down on the surface. The larger part needs
to be parallel to the surface. Most heads have a slight curve on the leading edge to help
trap the air.
Dwight
________________________________
From: cctalk <cctalk-bounces at classiccmp.org> on behalf of Chris Zach via cctalk
<cctalk at classiccmp.org>
Sent: Monday, December 16, 2019 3:07 PM
To: CCTalk mailing list <cctalk at classiccmp.org>
Subject: Bad heads on RL02: Worth replacing
So one of my RL02 drives (bought on Ebay years ago) is eating RL02
packs. Makes tings, then the disks have errors in my other RL02 drive.
Took a bit to figure out which drive was eating what, but I'm 100%
certain it's this newer drive.
So pulled the heads. The top one had significant gunk on it, the bottom
one a bit. Pics below.
Top: https://i.imgur.com/FELhF9X.jpg
Bottom: https://i.imgur.com/Tmsf5Nd.jpg
With alcohol and lintless swabs I managed to clean both of the heads up.
Top: https://i.imgur.com/gmACM4R.jpg
Bottom: https://i.imgur.com/SfZQV5F.jpg
Then put them back in the drive and mounted a scratch pack. With finger
on the load/run I let the drive spin up and when I heard tinging I
immediately spun down. Hopefully I didn't trash my scratch pack.
Top head has gunk, bottom one had a few flecks, but looks pretty ok.
Top: https://i.imgur.com/EAvgmuH.jpg
Bottom: (picture didn't upload)
Obviously the head is crashing, any idea why and if it's worth replacing
the head or should I put this drive out for parts? Yes I cleaned the
RL02 pack before putting it in.
Never dull.
CZ
