11 Oct
2020
11 Oct
'20
8:50 p.m.
Could it have been a 5V LED with integral current limit?
That would explain the odd behaviour.
Kindest regards,
Doug Jackson
em: doug at doughq.com
ph: 0414 986878
Check out my awesome clocks at www.dougswordclocks.com
Follow my amateur radio adventures at vk1zdj.net
-----------------------------------------------------------
Just like an old fashioned letter, this email and any files transmitted
with it should probably be treated as confidential and intended solely for
your own use.
Please note that any interesting spelling is usually my own and may have
been caused by fat thumbs on a tiny tiny keyboard.
Should any part of this message prove to be useful in the event of the
imminent Zombie Apocalypse then the sender bears no personal, legal, or
moral responsibility for any outcome resulting from its usage unless the
result of said usage is the unlikely defeat of the Zombie Hordes in which
case the sender takes full credit without any theoretical or actual legal
liability. :-)
Be nice to your parents.
Go outside and do something awesome - Draw, paint, walk, setup a
radio station, go fishing or sailing - just do something that makes you
happy.
^G ^G ^G ^G ^G ^G ^G ^G- In more laid back days this line would literally
sing ^G ^G ^G ^G ^G ^G ^G ^G
On Mon, 12 Oct 2020 at 14:33, Chris Zach via cctalk <cctalk at classiccmp.org>
wrote:
Ok, this is weirder: I put the "bad" floppy
drive on the bench and
started to take a look at it. First I checked the LED (yes, it's an
LED). With a bench voltage of 1.5 volts and a 100ma draw it lit up
nicely in the IR (detected by phone camera, so nice they can see the
light) and the photo transistor also seemed to work fine (at the sector
hole resistance went from infinite down to about 500 ohms). That's good,
so what is wrong?
I noticed I could crank the LED higher current-wise to 150 ma and the
voltage was still <2 volts. Interesting. Then I hooked a break-out
harness to the pdt11 to see what kind of voltage it was putting out to
the LED.
It's putting out +5v whenever the unit is on. Maybe it's current
limited? To check I hooked up the drive's plug to the breakout to see
what the LED was seeing.
+5v. And even weirder, the LED was not lit.
What the heck is going on here?
So I put the LED on the bench for a bit of a destructive test.
Disconnected the PDT11 from the breakout cable, hooked up the power
supply, turned up the voltage and the LED came on, then went *off* at
around 3v. At 5v it was dead off, no IR light as measured by the camera.
Turn the voltage down, and it comes on again. Up and it goes off.
And unfortunately at 9v it died (CRAP!) as I turned up the current limit
Yes, I forgot to set the voltage limit on the power supply, my bad, I am
boo boo the fool...
But this is weird: It looks like DEC put an LED in there with no current
limiting, and a straight +5 volts. And the LED is always on at this high
voltage? With no current limiting resistor? This does not make sense,
but the volt meter don't lie. I'm going to check the working drive to
see if it is limiting the voltage somehow. I'd say there was a resistor
in the LED assembly limiting the current, but if that's true my cranking
the voltage to 9v should not have blown it up, and it should not turn on
at low voltages then off at 5v.
Maybe the solution is to insert a resistor in series with the second
drive at around r=e/i or r=5/.1 (100ma) or 50 ohms.
Does this make any sense?
C