5 Dec
2000
5 Dec
'00
2:58 p.m.
Chuck McManis wrote:
1) Look for a set of three jumpers somewhere that have
'id' or
'addr' etched or silk screened near the board. If that doesn't work try
adding a jumper (carefully) at each point and then probing the bus until
the unit number changes.
No such luck with silk-screen labels, and the electronics contains
large numbers of switches and jumper headers, none of which are
obvious candidates for playing...
2) Read the code page and see if you can set
the LUN to sometong
other than 0
I like that idea and will try it, however it is still important to
learn how to setup and maintain the device.
It is a disk subsystem as contrasts a 'drive'; I will post a small
jpg of it perhaps later...
Michael Grigoni
Cybertheque Museum