15 May
2000
15 May
'00
8:34 p.m.
On Mon, 15 May 2000 SUPRDAVE(a)aol.com wrote:
according to my hardcard20 manual, do not set up and
entry for the hardcard
in CMOS. there may be a jumper on the hardcard for either 1 or 2 depending on
whether its the primary or second hard drive. there is a setup disk, but
normally shouldnt be needed. I have a copy if needed. the book also says that
it is not possible to LLF the hardcard.
All right.
I undefined the disk in CMOS (which now believes there is no hard disk
installed) but I'm having the same problem. FDISK hangs creating a new
partition, just after it says "Drive capacity is 77 Mbytes" or the message
to that effect.
I checked out the jumpers on the unit, and they are set for IRQ 11, BIOS
address C8000, I/O port 170, drive select 0.
ok
r.