24 Aug
2004
24 Aug
'04
8:27 p.m.
On Tue, 24 Aug 2004 20:51:18 +0200
Gerhard Lenerz <mail(a)g-lenerz.de> wrote:
I'd like to get it up and running again but I
can't get any of the
backups back on a "fresh" ESDI drive (the original died). According
to the Old IRIS FAQ the drive is supported. As far as I can see it
is also detected but the process that should restore the
installation back to harddisk dies quite early in the copy stage.
Did you
low-level format the drive? Bad blocks?
AFAIK each ESDI controller does its own bad block management. So you
need to re-low-level format an ESDI drive if you move it to an other
controler to get a valid bad block list.
--
tsch??,
Jochen
Homepage: http://www.unixag-kl.fh-kl.de/~jkunz/