26 Jun
2016
26 Jun
'16
2:58 p.m.
On Sun, Jun 26, 2016 at 5:48 PM, Noel Chiappa <jnc at mercury.lcs.mit.edu>
wrote:
My issue (M9312) has been that I can't get XXDP output to the screen, but I
can run the CONSOLE and initiate comms to and from the computer using
CONSOLE. When I run a XXDP routine I don't see anything to the screen so
far, regardless of what switch setting I am using.
Specifically
http://bitsavers.trailing-edge.com/pdf/dec/pdp11/xxdp/diag_listings/1140_45…
CQKC Test
Pages 18 - 61 and beyond provide switch registers and code to follow.
b
From: Fritz
Mueller
So far I haven't seen any place in PDP11GUI
to set anything other
than
port and baud rate
You might have to use native OS tools to do that. On Unix, that will be
'stty'; on Windows, you'd have to use native Windows tools to do that; if
you
go to the Device Manager, select your serial port, and click on
'Properties',
it has a tab ('Port Settings') for that (or, should I say, it used to - not
sure about the most recent versions, they're making it all smart-phone like
for brain-dead lusers).