18 Jul
2000
18 Jul
'00
3:26 p.m.
I'll agree with that. The instrument I use the most
is (obviously) a
multimeter -- in my case an old analogue one. One day I must get a Fluke
Got a few of those, my favorite is an Eico circuit tester/transistor
tester
I built in my teens. I like it as there are no diodes or other rectifier
devices
and it's stable in strong RF fields. I also use a Triplite 630 pocket
meter
(analog).
The fluke is a M12, well made, rugged holds calibration well. I also
have a weston, a digital volt meter that is probe shaped (NLS) and
an old tandy DMM I got back in 74.
comes a logic probe. For a long time I used a cheap
Tandy one, then I
upgraded to the LogicDart. And third on the list comes a bench PSU. Mine
Wish I had a Dart. I do have several I've made for my own use.
is a 30V 8A Velleman kit that works very well. It's
a simple design
All my bench PSUs are home made or resurected and modified H744
PSUs.
Ditto. I've found a little handheld 'scope
(only 5MHz on repetitive
waveforms, 500kHz single-shot) is very useful for checking for PSU
Old faithful is a NLS M15 I got in 74, been through a few sets of gell
cells. Another is a B&K 2120, at 379$(US) it's an honest 20mhz
triggered sweep scope, small too for the 5" screen. I recently got a
heath IO 10D-31 5mhz triggered also, replaced a few bad fets and
dialed it in and it's a fair scope.
the other instruments I've mentioned. Other stuff
(counters, sig-gen,
LCR
meter, etc) is very nice to have, and I'm sure
it's saved me a lot of
time, but I think I could work without it if I had to.
I have them and use them, I do/did a fair amount of RF.
As I said a few years back 'Your brain is the most
important piece of
test gear that you have'. No instrument will find the fault for you --
all instruments just provide information as to what's going on. You have
to know how to interpret the results.
;)
Allison