Industrial VAX 630 booting saga

The sequence that i use, robotically, is H<CR>I<CR>U<CR>B<CR> for: Halt, Init, Unjam, Boot but the B would probably do it. I think SHO DEV will work at this point in case the B(oot) dev needs to be specified explicitly, most likely not needed with a one drive system. John A. ----- Original Message ----- From: David Woyciesjes &lt;dwoyciesjes(a)comcast.net&gt; To: &lt;cctalk(a)classiccmp.org&gt; Sent: Tuesday, March 25, 2003 2:26 PM Subject: Industrial VAX 630 booting saga Well, I hooked my Digital BCC17-06 cable (3 BNC, LK401 jack) to the QVSS patch panel, then to my Digital VRT19-DA (Sony GDM-1960) & Digital VRT17-HA monitors. The VRT17 clicked like it was trying to do something, and the VRT19 had lines like the H or V scan rates weren't right. The keyboard beeped, and the caps light worked, so that's something. During this, I had the VT420 connected to the CPU console jack, and by fiddling was able to get some stuff. So... I figured I'd pull the video card (QVSS, VCB01), to force it to use the console port. I also moved the DEQNA ethernet and the M9047 (bus terminator?) cards over to fill the now empty slot. I sort of recall hearing that it needs to be that way for these beasts? Now... I can see it performing the normal system test on the terminal (set now to 9600/8/N/1). I'm getting somewhere, finally. :) Back up to the garage to see how far it got... Okay, with the CPU switches set to normal boot, and halt enabled, It completed all systems tests, and waited at the dead sargent for me. (Time to find a list of console commands. Maybe my VAXStation 3100 book may help) I've now changed it to halt disabled, to see how far it goes this time... David Woyciesjes wrote: reaction on -- ---Dave Woyciesjes ---ICQ# 905818