22 Jun
2002
22 Jun
'02
9:06 p.m.
"W.B.(Wim) Hofman" wrote:
Ethan,
John M.B.Wilson, creator of the Ersatz-11 PDP11 emulator wrote a program
fdcdemo that one can use use to create and duplicate RX50 floppies
on a 1.2 Mb drive using low density (360 kb) floppy disks. The program was
available on his site. Mind, you need a proper floppy disk controller with
more than one crystal but this is explained in the documentation of the
program.
Wim Hofman
Jerome Fine replies:
Normally when I wish to create (Low Level Format) an RX50 floppy,
I use PUTR. Actually, I looked for fdcdemo and can't seem to locate it:
http://www.dbit.com/pub/
Sincerely yours,
Jerome Fine
--
If you attempted to send a reply and the original e-mail
address has been discontinued due a high volume of junk
e-mail, then the semi-permanent e-mail address can be
obtained by replacing the four characters preceding the
'at' with the four digits of the current year.